Jump to content
Adzn3k

St205 plugin: wiring in a Bosch 2 pin donut knock sensor

Recommended Posts

Hi guys,

I'm fitting a Bosch 2 pin knock sensor in place of the oem single pin one. On have all the correct shielded wire but looking for info on wringing up, am I correct in thinking I only use 1 of the pins for the signal wire and the other is grounded like the shield?

Any info greatly appreciated 

Share this post


Link to post
Share on other sites

pin 42 for knock sensor input

pin 46 for ground wire and shield ground.

only ground one end of the shielding and make sure its connected to the pin or it may pick up more interference.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...