Hx30power

Hi all this question has probably been asked loads. But I cnt find any info I'm looking for the injector dead times a short pulse width figures can anyone help please.

Thank you for the quick response. I am looking a parallel turbo setup, as I think it would be easier to control, I want to keep auto as a road car but like all my cars I charge it to manual eventually lol. Well I need to do a bit of homework on the wiring and what commands what but really appreciate it. Kind regards bret

Hi all I'm just after some advice, I have a legacy bh5 that's in a stock automatic form, I want tk put a link on it as I have on my other cars, but don't k ow if it is compatible with the auto. Any views??

i did try this but the AFR the ecu was seeing was not the same as what was displayed ont the gauge. i have messed up its not lc2 its a innovate mtx-1 afr gauge

Hi all im after a little help i have a car in with a link g4+ fitted it has pretty much all the cal tables used other than cal table one. i haven never configured on these tables can anyone help me, innovates instructions say 0v = 7.35, 5v = 22.39. how do i scale the table any help would be greatly appreciated.

Thank you for the reply do you think I could use an arduino to control it??

Hello all after a bit of advice if possible? I am looking at build an A series mini turbo but want to run a VNT turbo and use the electronic actuator that it comes with. The info i have on the actuator is vague but from the info i have got i think i could run it on the wastegate and control it through the wastegate duty. any help on this would be greatly appreciated. Part number on the actuator is Garrett 767649

I'll try that thank you

Thank you for the response. I have removed the coil and put a temp ht lead fro. The coil to the plug with the clamp in line. The set up is falling. Ignition delay 65us and the dwell is 1.0ms.

Hi all please can someone help me with an issue I have?. I have a link g4+ on my boosted civic. Which I have fitted k20 ignition coils. When I test and crank the coils the fire the plugs but when I put my timing light in line r to the plug my light does not flash I have now tried 3 lights all work on other cars. It's the first start up since the build and cannot set ignition timing. Also I have a trigger wheel installed on the crank. Thank you in advance.