Jump to content

khalil

Members
  • Posts

    8
  • Joined

  • Last visited

khalil's Achievements

  1. V2.43 on both pin 35 and 36
  2. Only 2 wires for can tho? Iv tried swapping them around can H and Can L and even moved them to Can 2 but same story Any idea what I could have done wrong?
  3. hi adam no luck with those files please find the fault codes currently displayed when testing on both can 1 and can 2
  4. good day trying to confirgue a link thunder ecu to a motec SDL via can H and can L I Have tried all wire configirations with and without 120ohm resisters but cant seem to connect the two iv attached my base map and dash config file please help base map bat.pclr SDL-Dash-Link(1).U16
  5. Hi did those steps car started right up its revving pretty rought and backfiring in the intake then dies after few seconds log file attached rough.llg
  6. HI adam iv done all the changes you have advised we get spark just once when we start cranking then its gone here in current file, triggerscope, cranking log thanks crank.llg Trigger Scope Log 2023-04-28 9;16;28 am.llg base map 11.pclr
  7. hello have recently wired a Link Thunder G4+ into a offroad buggy using a LS2/L98 we have RPM when cranking but no spark on ignition test spark is fine attached is trigger scope and current tune please help Basemap.pclr Trigger Scope Log 2023-04-25 1;03;17 pm.llg
×
×
  • Create New...