Jump to content

ColinT

Members
  • Posts

    2
  • Joined

  • Last visited

ColinT's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. hi thanks for replies it is a 3 wire pot, power / signal / ground (as per richards diagram) problem i have is i get 5v in 1 position, and still like 4.99998v in position 10 so is that suggesting its been wired up wrong???? thanks
  2. hi we have a customer with a Link Monsoon, and is using the Life Racing / Syvecs calibration switch / rotary switch. We are using AN VOLT 1 for the cal switch (as 5v) We can configure the switch and assign it to go where we need it to so to do its intended job (boost tables) but as we move from position 1 - 10, we only get a very small voltage change, and no ammount of fiddling with voltages gives a wide enough range. We have been told we need to use pull up resistors in the wiring, and apparently this is a very common cal switch that is used. so must have been done plenty of times. does anyone have a drawing / diagram of how they have wired one of these up please ? thanks in advance
×
×
  • Create New...