Jump to content


  • Content Count

  • Joined

  • Last visited

Everything posted by Bananawasp

  1. Excellent thanks for that info. I'll try it without first then and see how my car performs I'm not gonna be anywhere near 750bhp (probably closer to 350bhp bhp on e85) so it sounds like I shouldn't have a problem.
  2. Pipe with out fittings please. I have seen a bypass fitting that doesn't restrict fuel flow, where the sensor clips in to. This would work really well with my setup but it will only accept a certain size sensor.
  3. Hi I'm just wondering if someone can tell me the length and diameter of the link ethanol content sensor pipe? I have a return less fuel system and need to buy a bypass mount to fit it my fuel system. Thanks
  4. Thanks a lot for your help id prefer a faster response but could be persuaded by cost. I'll check out the options and go from there.
  5. Bananawasp

    EGT sensor help

    I have a link g4+ for my mini r53 2003 and I am looking to add an EGT sensor. Is this straight forward to wire in similar to the pressure sensors. Im pretty confident with wiring and setting up. Just need to know if I need any other parts or just the sensor? Im wanting to make a boss that will screw into a lambda sensor hole then the EGT sensor screw into the boss. Thanks
  6. Hi I have an link pressure sensor that I'm wanting to setup for a safety feature can someone point me in the direction of a thread to configure the link ECU I'm hoping to get rid of my factory fitted oil pressure sensor if I can use that input? Thanks
  7. Excellent seems to be pretty similar then. Thanks for your response.
  8. On idle what should I expect my injector duty cycle to be. I'm trying to work out my resolutions in the fuel table. I have my injector master fuel at 6ms with plus 20% trim. That's giving me around 38% in my fuel table on idle but my injector duty cycle seems really low at 1.6% maybe that's fine I'm relatively new to this just seems low to me. I'm running 550cc injectors on my R53 mini cooper s. Thanks
  9. So after changing my settings i got the lambda sensor working. In the mode drop down box I selected the setting for mini r53 and was hoping it would just pick up the setting. Thanks for everyone that helped!
  10. Hi I'll try it again. On the G4+ mini link it automatically adds some of the settings I might try and use the user defined instead. I wasn't sure at first if I was using the pins on the side of the connector. Ie when you mate the connectors together pin 4 on the ECU is pin2 on the canf connector if you get my meaning. Thanks for the response.
  11. Bananawasp

    Can lambda help

    Hi all I have just purchased a can lambda kit to go with my link ECU. I have follow the instruction to wire it but I'm struggle to find the can device in my ECU. I have wired the can high to pin 3 and I believe can low to pin 4 on the ECU side. Does that sound right? Is there something I'm doing wrong? Thanks
  12. Hi everyone new to the group. I have just purchased a new ecu for my 2003 mini cooper s. But I have noticed that it says on all the paper work that a map sensor is not included. My mini has 2 map sensors as standard will these be ok or do I need to buy a link one? I have also purchased a a CAN wideband lambda sensor. But for what I can gather that will need an additional harness to be able to connect it up and use it. If I run the link CAN lambda sensor does that then mean I can remove or take out my standard narrow band sensors? Thanks
  • Create New...