Jump to content

Godschylde777

Members
  • Posts

    7
  • Joined

  • Last visited

About Godschylde777

  • Birthday 12/12/1971

Profile Information

  • Gender
    Male
  • Location
    Houston Texas
  • Interests
    Motorcycles, Cars, and books

Contact Methods

Godschylde777's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. Ok so nitrous switch can go to Di......pressure switch to volt 6 & Innovate to Volt 7?
  2. Ok I figured it out. I will copy and paste my questions to be answered here. Thank you so much for help given and future assistance. Ok great. My next question is My nitrous activation. I already have everything else wired up. I have the extension harness x2. Which wire is a good one to connect the nitrous activation, and the nitrous pressure switch? Again Thank you for your assistance. Wait, Wait lol. Also my Innovative wide-band. Do i now connect it to the external harness or do I splice it into the existing front o2? If the external harness, which pin on the pic?
  3. Ok, so I ordered the cable as listed in the diagram below. The canpcb cable. Will I still have the interference you mentioned? Also does the brown get grounded or just leave it alone? And the yellow and grew are also left alone?
  4. Hello. So I have a question. I have an mxs strada and an evo8 g4+. I have the cables listed above. From the can dash cable, it says the ecu Rx is grey, and the ecu Tx is yellow. What wires does this go to on the can dash? I just have it matched up and also do I run the brown to the black from the ecu or do I run it to a grounding source?
×
×
  • Create New...