alexjohn

Need help 1jzgte use coil k20 setup dwell time?

Ok adam

Ecu is running in boot mode and cannot connet...need help?

tq adam

2jzgte link strom idle to low use 2wire isc..startup to low.need help about setup Log 2020-02-11 8;54;24 am idle low.llg

hi benginetuner how u do the engine light and alternater light at rx8 dash work? the wiring to connet please?

HI ADAM ask some question about the alternater wiring ?the d1 wiring to alternater light is right?

canbus file for rx8 runing gauge oem....use engine 1jz ecu strom ?

the canbus file for can bus rx8 1jzvvti ? ecu link strom

isues timing for nissan 15 degree offset -98 at pully mark 15 at three line is correct or wrong lock timing?

Oli pressure so low aready test

Aux 1 test pwm solenoid have Clicking...i test on the solenoid open little

i try run the engine have the load... the vvti counter error....

fisrt start run vvti have sound is error ....second start is normal back no error

already set vvti mode 1jz ,cam angle off,trig 2 vvti off 174 still error counter 1jzvvti 4.pclr Log 2019-01-20 10;35;59 am run5.llg

vvti solenoid is connet cam control 1jz on .cam type off. no error Log 2019-01-19 6;46;27 pm run4.llg

cam control mode off and cam type.... is normal no error vvti Log 2019-01-19 3;55;23 pm run2.llg

vvti off and disconnet vvti still error.... 1jzvvti file.pclr Log 2019-01-18 6;51;16 pm run 1.llg

Trigger Scope Log 2019-01-17 10;05;50 am rpm2k.llg

Log 2019-01-15 4;42;38 pm trigger vvti problem.llg Trigger Scope Log 2019-01-15 3;27;51 pm trigger.llg

Test pulsecount 2 off still errors counter ...what have to check please?

Confuse vvti setup?