Slomotion
Members-
Posts
19 -
Joined
-
Last visited
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users.
Slomotion's Achievements
-
Cheers will do, you are a. Legend thanks for your guidance
-
Hi Adam swapped the 5v with tps - (as the voltage was showing the in the tps -) now can open and close the throttle body by the accelerator. Have I got it right?
-
I think I found the problem which is the TB connection plug as I took the TP main out as well as the sub and ran a volt meter and ran 5v circuit no issues. Ordered a new plug and see if that does the trick
-
The voltage did not change
-
Hey Adam, followed your suggestions and changes with no joy. I had the Brandt system taken out but not sure if this would have any bearing on this issue I might hook up the old ecu and see if that works
-
0 280 750 473 Is on the tb
-
I can’t figure out where it is grounding, should I replace the throttle body pin adapter to see if that could be the issue?
-
Hi Adam, no voltage change when moving the blade with e throttle off
-
A few less codes come up Now have the following wiring format 1. motor (-) black 2. tps (-) black/grey 3. tps (5v) red (volt meter confirmed 5v) 4. motor (+) yellow 5. TPS 2 (out) green 6. tps 1 (out) blue Have I got blue and green wires the wrong way around? Or tps - and tps + 5v the wrong way round? Or both?
-
Thanks just charging my laptop now
-
I’ll try the reversal of yellow and black and have not checked the ecu yet as the tb doesn’t make any movement or noise. Getting it tested tomorrow
-
After taking my car to three workshops and still not running I have finally seen the same harness wiring for the throttle body, yes it has been a long time since the last question it has been a long journey. Currently I have the pin out as follows 1. motor (-) yellow (same size wire as motor + so assume negative) 2. tps (-) black/grey 3. tps (5v) red (volt meter confirmed 5v) 4. motor (+) black (voltmeter confirmed 12.8v) 5. TPS 2 (out) green 6. tps 1 (out) blue throttle body still not moving on start up sequence or even with 9v battery test rig. any assistance is greatly appreciated as I don’t want to waste another year working on the same problem without success. many thanks, kim What I believe the wiring for the factory is as follows 6. blue tb main 5. red 5v 4. green tb sub 3 black/grey sensor ground 2. black tb (+) 1. Yellow tb (-) This picture was off a 2007 sti wiring harness for the throttle body.
-
Hi all, I have installed an Bosch 82mm throttle body but am having a few issues with the wiring colouring. I have the following wire colours but can open the throttle body but still having fault codes. Green Red Yellow Black Blue/black Blue can someone clarify what colours are for what. cheers, kim