Eversteijn

Here's mine. It will get you running. See pclr file attached below. SR16VE_Locost_Clubman.pclr

Here's mine. It will get you running. See pclr file attached below. SR16VE_Locost_Clubman.pclr

Just fixed all my problems so far. Car runs fine now. Had a hesitation issue. Ended up being a clogged Proflow brass micron fuel filter (brand new). Put a new Cooper WZ201 fuel filter in and she runs fine with no hesitation under load. Thanks Adam for your expertise! If anyone is trying to setup a SR16VE or SR20VE on a Link G4+ here's a pclr file that will get you running. See attached file below. Regards, Eugene Eversteijn SR16VE_Locost_Clubman.pclr

Pin 5 on the distributor goes to pin 3 (1st switch on signal), does this need ignition power? When I plug the stock ecu in it runs and has 12V accoss it. When I plug the Monsoon in its at 0V. Thanks.

Managed to get the triggers working, had to earth PIN 4 which switches on the ECCS relay. Still doesn't quite start.

Getting no Trigger signals or rpm. Will give you a call tomorrow. I've tried doing the test ECCS sync.

4. Yes, It's a 2 wire magnet wheel speed sensor. Was wondering if I can tap into it for the ecu or meh? Love the trumpets! Will probably go that way after the car is passed by transport Gotta run all the emissions rubbish first on the stock ecu Thank you for answering my questions so promptly. You deserve a pay rise good sir!

Thanks Adam! Just a few more questions: 1. Should I wire the SR knock sensor (single wire) to Digital Input (Knock 0-5v) or to Aux Output (Knock Window)? 2. Do I need "Start Position" and a "Ignition Switch" to Digital Inputs? 3. Is "Oil Pressure Switch" to Digital Input a waste of time? 4. Can I wire a Vapor Dash speed signal to "GP Speed" Signal (Digital Input) https://www.trailtech.net/752-x 5. Do I have to adjust the "MAP Sensor" (An Volt 5) for the internal MAP in the Monsoon? 6. Aux Output - Ignition Drive 1 go to PIN 3 or 1? 7. An Input - NB Oxy go to PIN 19? Do I have to wire the O2 heater? The O2 sensor is on the extractors so it heats up pretty quick. 8. Gnd Out go to pin 21? 9. +5V to PIN 37? 10. Shield/Gnd to PIN? Bare with me i'm learning... haha! I'll be taking the Clubby to Rob Chapman in Cooroy for a tune. Hopefully this will get me there. Is that what I think it is in your profile pic??? Cheers!

Hi all, I'm new to tuning and would like someone to double check my pcl file before I continue. I'm running a standard SR16VE nothing aftermarket apart from this Monsoon ECU I want to install. I'm kinda stuck on the Triggers. Which wires do I run from the pinout to Trigger 1 and 2. I figured T1 = 30 - Crank Angle Sensor now what about T2? Also do I have to wire in 22 - crank angle sensor 180 degree and 31 - crank central sensor 1 degree? Even if someone could write me up a quick installer I/O Table that would be cool. Your help is much appreciated. See attachments below. Regards, Eugene Eversteijn SR16VE_Locost_Clubman.pclr

S15 and Honda Civic base maps will get you in the ball park. Double and triple check!