Yetchh
Members-
Posts
12 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Everything posted by Yetchh
-
Yeah it's connected to a vac port on the plenum. I'll check map readings tomorrow, think they're all ok. I've set base timing at the factory 8 after and full advance at 27, I think this was set at zero but I'm not sure.. I'll have to find out.
-
Ok, would a long vacuum hose cause a delay in the ecu reading vacuum? It's taking a reading from the opposite end of the plenum from the tb, should it closer? Also I have a full fuel and ignition table for this engine but it's for a very early g1, how would I translate this across to a v5 table? Sorry for all the questions..
-
Ok I fixed it, don't ask.. Still interested to know if adjusting the rows down and master up (or vice versa) affects the accel numbers?
-
Hi, I've got a fairly large flat spot off idle on 2.0 engine with a 60mm Tb, accel low and wake inj are maxed out but its still there. Will adjusting the rows down and the master up affect the accel numbers? Thanks.
-
Is it possible to set up a wide band Oxy if there's no port for it? As it's a v5 link the wb is in the menu after nb but I don't have the four pin port. Cheers
-
Hi at @Simon, got everything wired up and running, had an issue with the fpr not releasing fuel at idle and cavitating but should have that sorted with a new fpr. One problem is the coolant sensor, from cold I either a) get a reading of 36c that drops to about 20 or b) get a reading of 96 that rises to about 105. I've checked the earth's and they're all good. It's there a way to calibrate it or do I need a specific type. From memory this was working with a very early g1 (97ish) it's not the stock mazda item.. Cheers, Thomas.
-
@Simon is there any way to do a factory reset? Cheers
-
Hi Simon, thanks for your reply. I'm assuming it uses the same loom as a v3.. am I able to run two injectors per drive or does there have to be a minimum of three per? I'm also using a Nissan throttle body, and the last time this engine was set up with a link (1999) I think there was a prob with the nissan tps, is there any specific brand I should be using? Cheers, Thomas.
-
Hi, swapped this link for an lemv3 I had that was set up for a 5mge, any info on this? V5 is pc tuneable or is it hand controller only? Am I right in saying it's set up for a 4age? I want to run it on an early 2.0 mazda egi engine. Thanks for any help.