Azza27

How do i get a negative number in trigger offset. When set to zero i have to much advance

Ah yes i get it to now.... all the diagrams ive been looking at are of the coil plug itself. Thanks for the help and the fast reply too. Any idea of the dwell setting for these

Each coil has 4 wires going into it. The plug has 7 wires sorry not 8

Does anybody have a coil wiring diagram for L98 coils. The coil plug has 8 pins

Ok thanks adamw. Does link still sell analog type contollers, due to the nature of installation the sensor will only be installed for tuning purposes and then removed. Also i was supplied a bosch LSU 4.2 sensor. Is this even compatible with the link can lambda

So your saying yes it does need some form of controller/ module. ie... the sensor cannot be wired directly to the g4x?

Have purchased a g4x extreme for an LS2 engine. Do i need a can lambda to run a wideband co2 sensor. From what i read and understand i do however other people are saying i dont. The ecu can run it without a can. Is this true

Yes i agree. I have done a few jet boats in the past however this is the first factory LS engine. I usually put the ecu, the map and lambda controller in a click clack type lunch box mounted vertically with a few small drain holes in the bottom. So far i havnt had any ecu temp problems doing it this way

Ok thanks adamw.. any other things i should be aware of when it comes to ls3 and a g4 extreme

I am looking at a g4 extreme onto a ls3 in a jetboat. Do i need to run 2 co2 sensors? Each bank of the engine has its own exhaust ie: 2 exhausts not connected together at any point