Jump to content

Aussiemick

Members
  • Posts

    32
  • Joined

  • Last visited

  • Days Won

    1

Aussiemick last won the day on May 16 2020

Aussiemick had the most liked content!

Profile Information

  • Gender
    Male
  • Location
    Orange NSW

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Aussiemick's Achievements

  1. I need the USB drivers for Windows 11 on my laptop. Could you send me a link to download the drivers. Thanks. Mick
  2. Just a quick question, I cannot get the fuel level to show on the Powertune gauge as there is no corresponding data source in their system. Will I need to create a new id in my can setup and what should this look like. Just a note, the calibration for vl's is low voltage for a full tank and high voltage for an empty one. Thanks.
  3. I am using a circuit diagram in a previous post for a 3uz in 2017.
  4. I want to setup a fuel gauge to put to a Powertune digital dash. What I need to know is what input I could use to get a percentage readout so I could read 0%, 50%, 100% fuel level from the sender.
  5. Aussiemick

    Can Bus signal

    The Can Bus oscilloscope reading appears wrong. The bottom graph is the actual reading from my setup, it does not look at all like the sample reading at the top. Any ideas. https://ibb.co/GtVSByS
  6. Here is the result of t5he latest oscilloscope reading. 2021-06-02 09_02_12.bmp
  7. Just a basic hantek oscilloscope and not 100% with the software but this is a screen capture. The speed sensor seems to be creating a signal. 2021-05-29 15_15_11 speed3.bmp speed sensor.txt
  8. Yes it is a 2 wire sensor DI6 and ground. I will see if I can get access to an oscilloscope. Thanks.
  9. Still the same problem with the changes.
  10. I will put that setup in and let you know the result. Thanks
  11. Straight to the ECU via DI6. DI6 states the input is inactive and no frequency reading. When I put the signal through wheel speed (wrong of course) it did recognize the signal as active but did not give any speed reading.
  12. Got my speedo sensor for R33 gearbox and set PClink up, but I cannot get an active signal to read the speed. Obviously have'nt got it right. I'll post the tune for a look to see what I've missed. `1746517451 ign adj.0-80 + speed.pclx
  13. Aussiemick

    Digital ground

    I am connecting my speed sensor, one wire to DI6 the other to ecu ground. I assume that the ground should not be connected to where other analogue grounds are connected.
  14. Do you have a list of instructions for installing Realdash via a can analyzer in G4X. I have a slip up in getting it to connect and am not quite sure where to look.
  15. They do but I cannot find it. Maybe have to get another. Thanks for the info. Mick
×
×
  • Create New...