-
Posts
8 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Posts posted by Rally037
-
-
drop canchecked a note - they will get back to you.
But - having configured one, here's some help.
In the canchecked TRI files, enter enhanced mode. Open the oil pressure TRI. You'll see a field for initalCALC (mathematics functions) about half way down. Enter 0.1 and your display will now read 3 bar.
Your ECU is likely to be wired ignition on so will go down on key off. Have you saved the config by hitting F4 and F2 in the PClink?
-
Been a bit of a numpty in the wiring diagram!
I have an Xtreme ECU and will get the CAN module for the LSU 4.9
Thanks for the tips on the tacho.
Steep learning curve - but all getting there.
I'll be in touch.
-
Thanks Adam
Speedo is a VDO programmable one that runs off a wheel speed sensor. I could wire a sensor direct to the speedo, but I'd like to have the data in the ECU and then send a signal to the speedo. I'm assuming I can wire AO to speedo?
RPM dial is the standard electonic Veglia Borletti electronic unit.... This could also come out of AO?
Yes, planning fuel pump, radiator fan, accusump and so on can be switched outputs from Inj 5-8
What would really be good is a way to take sensor inputs and then use them to drive the old 12v instruments.... rather than a "redundancy" based system on two sensors - lol
Really appreciate the tips! thanks in advance
PS: finally updated my profile :-)
-
Laying up the loom on my nail wall now and have all the sensors. ... Got a Fury ECU and working out the pins and sensors. Cam sensor, crank are OEM Lancia/Fiat 16v coupe items. I've a 60-2 trigger on the crankshaft. Here's a PDF with how far I've got. Best to get the paper right before cutting wires, so any comments would be good!
-
On 4/19/2020 at 8:39 PM, Bud said:
Hi
In case i have one base map from Lancia delta Hf integrale 8v from link G4 or vipec ecu
Thanks Bud,
I would be interested in the 8v one, yes please!
jp
edited: I now have a G4+ Fury
-
Hello folks,
I'm considering a Fury for my engine. It's a Fiat Volumetrico 131 / Lancia Beta type (as in reverse flow from Delta type) engine. I've converted a Delta integrale plenum (cut and swapped ends) and fitted the rest of the fuel injection of the Delta. No turbo, but an R10 Abarth compressor from an 037. So for this reason, someone with a Lancia Beta volumex (or second choice Delta integrale) would be a good start point. I've changed trigger wheel to lose the 4-tooth unit for a 32-1 which I can do that in the setup - but the rest of the maps would be handy to use as a base. Gearbox is an Audi transaxle - but not planning any flat shifting for the old girl :-).
Thanks
Supercharged Lancia 2 litre base map needed
in G4+
Posted
I know its a million years old... but this one is all resolved. Car is on the road.