yulius

Hello sir, today i test again use dwell 1-2-3ms but keep same, boost going high now until 2bar but rpm keep erotic when 5100rpm ++ and im try like 6 times, on 2times random not straight ecu show disconnected when the rpm erotic and if i try push pedal in stop position cars, can do revs 8k rpm normal file name ;log12 its shows disconnect when logging was keep running rchive (1).zip

hello, my limit was 400kpa now the log shows only 302kpa

hello , i see on datalog name :log1, i see the rpm going up an down start from 4900rpm, why it happen

helo sir Adamw, it just for the test my normal dwel like 3ms i use honda coils, this my new loging todays New folder.rar

hello i got some issue, anybody can help me, i got the engine like off like 1sec and it back again when pedals keep accelerate, and sometimes ecu like hank when datalog was record and the rpm it cut sametimes ecu disconect on the new version g4x ver 6.20.67 it was like the cars cant get over 1bar boost, but all the protections it show off, anybody can help me? my cars evo ix jdm with plugin g4x evo ix mods: individual coil and dbw active aem map.llgx

When turning the ECU power off, getting the following error in PCLink 6.19.65. Connection error: 1019 LINK_NOT_RESPONDING_CORRECTLY Not really affecting any functions, but quite annoying that I have to clear it every time I turn the engine on. im use link g4x plug in evo ix what should i do

hi can anyone help me, i just do 1. change a new wire direct to the sensor cam lh 2. make sure new wire no noise but keep signal extra pulse, when i pull the cars like dragrace mode. if i drive normal inlet lh all works good run normal works good.llg workslow good, dragmode eror.llg

hi anyone please help me to get the correct data for this DW injector 1000cc they give that data A and B thats 2mode not works, so i used data A and modified 12-14volts add 0.6-0.7 value and cars can iddle with MIN short pulse 0, and short pulse adder table 0 im still used oem resistor box, cause my injector low impedence anyone can help me 42M 1000cc Technical Data Sheet.pdf

sir , can you help me to get the correct data inj, i still used oem resistor box inj is this corect? and my firmware is that the latest? can you help me to setup my ecu?

can you help me to get better tuned? cause the data from dw only like that, i need assistant

yes i do tuned allready without CL lambda and accel enrich, but the response very bad, and the fuel lambda not flat if i flap throtle

hello, i tried many ways to adjust the data original from DW they give 2 type A and B. i tried allready but cant works i am on LINk pnp firmware 5.6.7.3631 i am used FUELPUMP DW 340LPH INTANK INJECTOR 1000CC 42M-02-1000-4 OEM FUELPRESS anyone can help? now the cars was going with my custom deadtime and inj shortpulse, but i got problem if we push the throtle 30% or 100% it will very bad lambda, and i try to off the accel enrich and CL lambda and turn on again all the ways keep same, anyone please help 42M 1000cc Technical Data Sheet.pdf

HI, ANYONE CAN HELP ME FOR TUNED MY EVO IX, I DO TURN OFF THE ACCEL ENRICH AND TURN ON BOTH WAYS ARE SAME, MY FUEL TRIMS HAS DONE ON SINGLE GEAR TUNED, BUT EVERYTIME WE PUSH THE TP LAMBDA VERY BAD