Jump to content

Mazda GTX

Members
  • Posts

    18
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Mazda GTX's Achievements

  1. Does GTX have Hall Effect or Reluctor sensor on ABS ? None of two wires are grounded, I try splice both wires, none is giving signal when tires rotate. (with or without ABS connected) If I ground one and try signal on other one - still no signal, with or without pull-up on. Same if reverse wiring. (with or without ABS connected) - I use DI 5 as input.
  2. Is it possible to wire in traction control, parallel to functional ABS, with some diode bridge, or I need to choose one of them ?
  3. Yeah, it's alive, it idle at full throttle, so far Thank You a lot.
  4. password: parole13 hopefully took it off.
  5. GTX latest.pclx seif.area.lv/LINKG4X/GTX latest.pclx
  6. Log 2020-05-23 10;11;05 am.llgx I tried trigger offset 45; 90; 135; 180; 245; 360.. Timing light gives some pulses on distributor input
  7. Some sparks are going in to distributor. seif.area.lv/LINKG4X/GTX latest.pclx
  8. triggerscope3.llgx TriggerScopeLog4.llgx TriggerScopeLog5.llgx
  9. seems it gets valid RPM but some trigger errors
  10. Still no spark while cranking, gasoline smell and it shoots one spark at the end after key is on off sometimes.
  11. This is faulty distributor picture, can You give a setting to try, before taking apart functional one.
  12. Timing light do not light up when cranking. On stock ECU car starts. There are some trigger errors while cranking... - Ignition test, Injector test, fuel pump test, works.
  13. Distributor where faulty, replaced distributor and engine still won't start, if cranking for a while it starts burp, should it start with mx-5 maps ? What else I might be missing ? http://www.seif.area.lv/LINKG4X/GTX burp burp.pclx http://www.seif.area.lv/LINKG4X/GTXtest.pclx
  14. Can't get trigger 2 to post correct, If both triggers set to reluctor, then I get this graph, does it means trigger 2 is connected right way:
  15. TPS Sensor is faulty, Thank You for pin-out. Still car should start without it, so far I get only gasoline smell from it, no spark. If both triggers are set to hall/optical, 1.(trigger 2 pull-up is on.) 2. (trigger 2 pull-up off.) I get some gasoline smell and one single spark.
×
×
  • Create New...