Rune skredsvig
Members-
Posts
6 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Downloads
Everything posted by Rune skredsvig
-
Link G4+ canbus lambda problems. Please HELP..
Rune skredsvig replied to Rune skredsvig's topic in G4+
The lambda has had power in all my troubleshooting, I have checked that it has power in the connector and felt that it is hot. I just wired it directly so it cannot be any issue with the power supply that causes my problem.. the red and orange wire follow the can loom into the ecu and goes out of the ecu Following the wires more “natural” and tidy look when it’s done. -
Link G4+ canbus lambda problems. Please HELP..
Rune skredsvig replied to Rune skredsvig's topic in G4+
White Or Green wire from marking to marking, 0,01ohm. its a v1.4. I have made a mistake when I made the connections in the dtm4 connector at first as you saw at the first pictures, I found numbering at the connector and followed this. But when I saw the picture I found the colours crossing and checked it out and switched them as the wiring diagram showed. But I still cannot program the can lambda. By the way ... your service and response at this forum is incredibly good.! thanks. -
Link G4+ canbus lambda problems. Please HELP..
Rune skredsvig replied to Rune skredsvig's topic in G4+
While troubleshooting I have connected +12v and -0V directly to the battery and connected can like in this picture.. and I still get errors... Gamla 2.pclr -
Link G4+ canbus lambda problems. Please HELP..
Rune skredsvig replied to Rune skredsvig's topic in G4+
I think this ecu has been in the shelf at the dealership I bought it for quite some while but it is not used before now, the lambda an can loom is newly ordered from link. I have Downloaded and updated the firmware on the ecu. I had to do this before I could even start to touch the settings for can in pclink. Can L- green and CAN H - white, brown is not in use, I have just tried it out as -0V once in my troubleshooting.. (reason for the crimp) -
Link G4+ canbus lambda problems. Please HELP..
Rune skredsvig replied to Rune skredsvig's topic in G4+
I have allso tryed to terminate a resistor ar 120 Ohm without any luck. The Power is from a relay i have installed nearby the Ecu that is supplied by direct + 12v from the battery, I have programmed aux 11 to signal the relay ignition power when ignition is on. But I have also tried to wire it so the lambda has power all the time to see if it needs ignition signal from “the key signal» ground is connected to chassis nearby the ECUs location. -
Hi ! i have BIG issues getting my brand new can lambda programmed into my brand new g4+ Ecu . i have done a lot of work trying to get this into the program in the ecu without any luck. the ecu doesn’t find the sensor in the canbus, the lambda has power and gets hot when I try getting it in. Can someone please try to help me with a solution.? I only have the lambda in the can system.