Jump to content

DobromirBG87

Members
  • Posts

    14
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

DobromirBG87's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. Tried both and same thing happened.
  2. Well when I hit capture and,crank the car the,whole screen freezes. After a,minute it un,freezes. However the,car started with the ls1 sensor with,the ls3 crank wheel. Not sure how. Will share update shortly.
  3. Ywa but the program stall and when unfreeze it shows straight lines.
  4. Swapped the sensor but yet again no rpm. The only way I get stable rpm is when I use multitooth 60-2 hall effect both triggers with pull ups and on trigger 2 cam level sync but no readings in scope and doing 120-30 on cranking...
  5. So no chance runing ls3 with ls1 crank sensor ?
  6. Hi Adamw, I am a bit confused. So no chance to read the 58x with the ls1 24x crank sensor ? Aren't they both hall effect ? I mean only with changing the trigger settings won't make difference ? I guess I neex to take crank sensor from ls3 then. The cam is ls1 layout so I guess the sensor will be correct.
  7. Hi Adamw, Sensors should be from the ls1 or at least I guess so need to confirm this however why the scope function bugs when I try to use it ? Can this be from low battery ? When I use it the whole program stall and when un freeze it only shows straight lines...
  8. Hi guys, back to the drawing board.. i blew the LS1 and put in new LS1 with LS3 crank and new Link Xtreme ECU and now i cannot start it. I think LS3 have 60-2 trigger wheel but not sure about the cam. All is the same like wiring and sensors. Strangely enough when i try to see scope reading it is only straight line both trigger one and 2. Did someone came across such issue ?
  9. Well, yes as the trigger was 3-12, changed to 5-10 rpm came and started right away
  10. I am ashamed to say that but the car was out of fuel...put 15ltr in the tank started right away.
  11. Hi Adamw, I am attaching the map i am using and log from cranking the car. Log crank trigger issues 2020-06-11.llg LS1 e36.pclr
  12. Trying now and nothing...signal from both sensorssensors is present but won't sync...
  13. Hi Adamw, Will try this today however what about trigger edges ? Should they be failing or rising and also the trigger setup?
  14. Hi guys, I am having issues starting my ls1 with link g4+ atom and I cannot figure out what is going on. Sensors are wired correctly and when hit f12 it shows signal but won't sync so I guess until it syncs I won't be able to fire it up ? Trigger setup is ls1 3-12 which was the setup anoter engine before this ine used to work with but this one just refuse to start...I think they are hall sensors and provided sensors with 12v.
×
×
  • Create New...