JKauh

Holy crap you just made my day. Set trigger offset to -213 and master fuel to 30. Fired right up no problem. Don't know how well it runs or if it'll stay running since I don't want to wake the kiddo. Thanks for the help!

Never mind. I realized how you got -213

Sorry for the newbie question, but how do you get -213 as 360 off of 147? Tired -213 and no noticable change. Ignition tests spark on correct cylinders. The VK has the ignitors built into the coils. From what I can find online the injectors look to be 286cc.

Hello, I have a VK56 I'm trying to get fired up for the first time. I have a 12 tooth Ross Performance crank trigger setup. I have ground the cam pick up teeth down so there is only one. While cranking I am getting RPM speed, both triggers reading "yes", and no trigger error counts. Ignition and injection both test good when using the test functions. Fuel pressure reading is good at regulator. I set my ignition timing to 15 degrees while cranking. I thought maybe the trigger offset was off 360 degrees, but I didn't notice a change when I switched it. While cranking, I am getting an occasional single "pop" and i can smell fuel from the exhaust. Thanks! VK56.pclr VK cranking.llg

Jumped battery voltage directly to injectors. All the injectors seemed to be stuck shut. Took a couple taps of the jumper wire to the battery but they are all clicking properly now. Thanks for the help!

Thanks for the help! Ground the teeth on the cam down and error counts went away!

I am able to perform the injector test and confirmed the injectors are getting proper voltage, but when I run the injector test I can barely hear them clicking. I confirmed each injector clicked when selected. Even pulled the injectors out to see if any fuel was even coming out(which it's not). I'm wondering if this would be an issue with my settings? Thanks.

Hello! I have a VK56 with a 12 tooth crank mounted trigger wheel with no missing teeth. When viewing the runtime values while cranking I am getting RPM and Trig 1 & 2 Signals both say 'Yes' but I am getting Trig 1 error counts. The trigger scope for the cam is showing a 1-3-4-2 pattern. Will i need to modify the cam so there is only 1 tooth? Thanks