[email protected]

hello all, new trigger solve cutout/stall at 3000 rpm, now i have intermittent crank no start/ backfire . crank again and it will fire up louie3tgte.pclx

hello all, new trigger solve cutout/stall at 3000 rpm, now i have intermittent crank no start/ backfire . crank again and it will fire up crankpopnostart.llgx 3rcrankrun.llgx

update: thanks Adam , it was the trigger wheel, i've change it to link tw an everything works great

Thanks Adam, this engine had the tec3 gt electromotive ecu , i switched it to link and used all existing sensors and trigger wheel, i will check closely on what you see, do you recommend replacing wheel with a different one? thanks again and regards, Ray

logged this one today 1105455log.llgx PC Datalog - 2022-11-5 4;51;59 pm.llgx trigger scope TriggerScopeLog2.llgx

toyota 3tgte with 60-2 multi/missing tooth / toyota 3sgte magnetic crank sensor. if anyone can please point me in right direction: i have attached log file, thanks 3000rpmstall.llgx

will do, thanks Adam

can someone help me figure out why my trigger signal is dropping at around 5700 rpm getting trigger faults . thanks PC Datalog - 2021-10-26 3;58;40 pm.llgx

thanks for the quick response

can we run two denso cop on 1 ign driver?

thanks Adam, will try it

crank no sync tooth thanks

Hello Guys, can i use 36-1 missing tooth trigger on distributor type ignition? if so what ecu setting do i use? thanks, Ray