Jump to content

aconis

Members
  • Posts

    10
  • Joined

  • Last visited

Everything posted by aconis

  1. aconis

    2JZ + AT ECU choice

    Sad news. Thanks anyway.
  2. aconis

    2JZ + AT ECU choice

    Can you guys suggest me if there is any Link ECU which can control factory A340 transmission as I want to replace my current aftermarket ECU. For the rest options I need to have Link is covering everything, I am just in doubt about AT control. It is 5 solenoids transmission. Cheers.
  3. In regards to fuel timing, what would be the ideal injection time anyway? To the open intake valve or right after the exhaust valve is closed? Many people says it should be injected against closed valve.. I understand on high load when injector duty is nearly 80% it doesn't make a big difference, but on the low load and cruising it does, i think.
  4. Thanks a lot! This is awesome answer! ;-)
  5. As far as I understood there is no sense to pair injectors same as wasted spark ignition coils: 1-11, 4-10, 9-3, 8-6, 5-7, 2-12 due to we don't want to leave fuel wetting on the port walls and it is better to pair in adjacent cylinders according to firing order, i.e. 1-4, 9-8, etc. Can anyone confirm it?
  6. Hope this table taken from engine manual can be helpful.
  7. And if firing order is: 1-4-9-8-5-2-11-10-3-6-7-12 ?
  8. aconis

    ECU for V12

    So, basically both Fury and Xtreme can do the job but the only difference is lambda controller. If Xtreme doesn't have onboard lambda controller this means engine will run according to the maps initially tuned without action taken if AFR doesn't match, am I right? And if I use Fury I would need second lambda controller connected via CAN to maintain second bank closed loop control?
  9. aconis

    ECU for V12

    So if I run grouped injectors (6 groups) and if I switch to single DBW throttle will I still be limited by ECU supporting 12 cylinders, such as G4+ Thunder or in such setup I have more choice? In regards to knock sensors I think I can use one from each bank and the rest connect to independent knock detecting device.
  10. aconis

    ECU for V12

    Hello everyone. I need a help to chose proper ECU to run my NA V12 engine swap. It is 12 injectors, 6 wasted spark, 4 KNOCK SENSORS, 2 DBW throttle and 2 MAF sensors (considering switching to a new intake plenum and using 1 DBW throttle and MAP sensor). The car I’m swapping engine to is BRZ 2012. Thanks to everyone who can give me an idea of what ECU will work for me.
×
×
  • Create New...