Loganbm

Did want two just because of the icons on the buttons ⬆️ High boost ⬇️ Low boost. But this isn’t important. Can be one if that a better.

So left hand side buttons (no button pushed 3.32v) 1 4.57v 2 4.19v 3 4.85V 4 3.63V right hand side (no button pushed 3.32v 1 1.18v 2 3.04v 3 2.20v 4 2.72v pushing more that one at the same time gives me another voltage. Eg left hand side 1 left and 1 right gives me 1.73v so lots of combos. Also the An volt I have a Cal table setup as % Could run second an volt so one for left hand and second for right hand. If that helps

So I’ve wired up steering wheel buttons as a analog input, which gives me 8 buttons from the one analog input. Have one button as fault clear virtual aux 1, button two as data logger Virtual aux 2, theses work fine as a momentary buttons. But can’t work out the best way to setup buttons for boost table 1 inactive (button 3) and boost table 2 (button 4) hi boost low boost. Also look for info on dash can-bus eg Engine light, rev counter, oil, coolant temperature. Help