Ryan21

Thank you! I assume the pin locations are correct? Or should I swap the 12V and ECU Aux output?

Hey Adam, It has been a while lol. I hope you are doing well. I'm NOT using a factory loom, so I have a question about wiring the VTEC solenoid without the additional relay as you stated above. Did you mean to wire that connector as seen in the image on the left? The factory connector is in the center and the factory Honda diagram is on the right. It looks like it just needs a switched power and ground. I think I'm a little confused.

I haven't been able to figure out if it is possible to use a knock sensor on a link monsoon. I know you can use the Digital Inputs for a 2nd cam sensor, so that's what made me think it could be done.

Thank you so much!

Thank you. I found that basemap. In the ecu layout it says there is only two triggers being used. The k series has 3 trigger type sensors, 2 cam and 1 crank. How would I know which cam sensor to use? Or is there a way to use both?

Does anyone have a k24 on a Link Monsoon? If so, could you post a picture or explain your installer I/O table? Thank you, Ryan