[Honda K24 Link Monsoon]

Thank you! I assume the pin locations are correct? Or should I swap the 12V and ECU Aux output?

[Honda K24 Link Monsoon]

On 2/14/2021 at 3:34 PM, Adamw said:

The base map shows exhaust cam connected to trigger 2 and inlet cam connected to DI1.  There is wiring info in the help file, I will attach below.  If you are using a factory loom you will need the relay for the vtec solenoid as shown in the diagram below (since factory ecu switches 12V side), if you are making your own loom then you can do it without the extra relay, connect it direct to an aux output and the other side of the solenoid to +12V.    

Oh, be aware also, Im pretty sure the K24 crank sensor pinout is different than the K20, so you need to research that yourself.

 

 

Hey Adam,

It has been a while lol. I hope you are doing well.

I'm NOT using a factory loom, so I have a question about wiring the VTEC solenoid without the additional relay as you stated above. 

Did you mean to wire that connector as seen in the image on the left? 

The factory connector is in the center and the factory Honda diagram is on the right. It looks like it just needs a switched power and ground. I think I'm a little confused.  

 

[Knock Sensor Monsoon?]

I haven't been able to figure out if it is possible to use a knock sensor on a link monsoon. 

I know you can use the Digital Inputs for a 2nd cam sensor, so that's what made me think it could be done. 

[Honda K24 Link Monsoon]

Thank you so much! 

[Honda K24 Link Monsoon]

Thank you. I found that basemap. In the ecu layout it says there is only two triggers being used. The k series has 3 trigger type sensors, 2 cam and 1 crank. How would I know which cam sensor to use? Or is there a way to use both? 

[Honda K24 Link Monsoon]

Does anyone have a k24 on a Link Monsoon? If so, could you post a picture or explain your installer I/O table? 

Thank you, 

Ryan