Jump to content

tioklou

Members
  • Content Count

    11
  • Joined

  • Last visited

About tioklou

  • Rank
    Member

Profile Information

  • Gender
    Male
  • Location
    Greece
  1. Thank you very much for one more time for your help. Iwant to ask you if you support this extension ecu harness in order to make the cable change and to leave mine in stock form.
  2. Of course it is and i have already read it. But the problem is that this ECU is for evo and the information is to connect it on the exhisting AFM connector. The engine i have does not have a AFM but only map sensor. Is it possible to tell me the pins of of the stock evo ecu and the pins of the evolink to connect it? Thank you for all your help.
  3. Hello again, I have in my hands the evolink G3. The Ecu doesn't have an internal map sensor but only an external unit. How will i connect it because you said that "factory MAP sensor goes to a pin that is not connected to anything in the Evolink" On its back side has a hidden usb port. behind a sticker. I attach some pictures of the ECU map sensor and cables.
  4. Thank you for the loom part number. I thought evolink is like linkplus and has Knock control input. So distributor only needs the appropriate values on software and nothing more. Is there anything else to have in mind before first start up?
  5. Do you also offer extension ecu harness for evo in order to add knock sensor or wideband O2 without make any mods on the stock harness?
  6. Thank you for one more time for you useful information and your help. So distributor needs only software tuning through the ECU? I will try to find the information about toothed wheel on the distributor and i will ask your help for calibrations. Is there something else i need to take care of? Thank you.
  7. Thank you very much. I have a manual transmission so we are fine. I also have a few questions. 1. How about the dizzy connection? 2.I have also a rear O2 sensor that is not seen in the ecu pinout picture. 3. Tps sensor,air intake temp sensor,coolant temp sensor,ISC motor,crankshaft sensor are in the same pins? 4. immobiliser (The evolink G3 i want to use is for mitsubishi evo 7-8).
  8. I made a mistake about the ECU model and change it in the first post. I found some more information about the ECU but i need your help as an expert. http://www.kaxlon.com/mcs/manualer/colt_lancer_98_electrical.pdf pages 52-59
  9. Thank you very much for your reply. Unfortunately i could not find any pinout for my ecu until now except for the number of pins and the number of connectors that are the same as evolink G3.
  10. Hello, I want to ask you if it is possible to use the evolink G3 on this car that has an ecu with same (4)pins. The car is a mitsubishi lancer VI 1997 (CK1A) and has the 4g13 engine 1300cc 12v with map sensor and dizzy. Stock ecu model:MD328466 Thank you very much.
×
×
  • Create New...