Ben80
Members-
Posts
26 -
Joined
-
Last visited
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users.
Ben80's Achievements
-
I've sorted this out, I purchased a USB hub and its now working.
-
G4X (MX5Link), and I assume its powered up as my car runs? I cannot see any blue light here, where is it located?
-
USB, COM and Wifi do not work
-
Ben80 started following Laptop not connecting to G4X ECU
-
Hi, I have a new laptop running Windows 11 that won't talk to my G4X ECU. I have installed PCLink Ver 7.2.2 Attached are the screenshots showing whats happening. What can I try to get them to connect?
-
No I didn't. I've done that and have now got it reading. Thanks for your help Adam!
-
Ok, I've wired in the resistor and connected it to pin 4 in the 23 pin amp plug. When I go to the Live Measures screen I can't see where the voltage reading is? I've got the old Fuel Level custom sensor that I had setup before. I removed that custom setup but it is still showing on this screen for some reason.
-
So basically instead of the existing fuel level signal wire plugging straight into the back of the 23pin amp plug, i need to insert this pull up resistor and then re-attach to the 23pin amp plug in the same pin location yeah?
-
Thanks, I've had a read through both docs. I need to get a resistor but do I need to buy a binder connector? And does this binder connector plug straight into the mxg dash?
-
This sounds like the issue as I don't know what you mean? Could you explain what I should have done in setting this up properly?
-
Hi, I'm trying to configure my fuel level to my MXG 1.2 dash. I've got 18 litres of fuel in the car yet my dash is reading 52 litres?? I haven't finished measuring the ohms and fuel levels as I wanted to check the accuracy. Anyone know what I've done wrong in the configuration? My vehicle is a 1989 Mazda MX5 with an aftermarket fuel pump.
-
Vaughan reacted to a post in a topic: Connecting a GPS09 to MX5Link with MXG 1.2
-
Great, now working - thank you!
-
Vaughan reacted to a post in a topic: Connecting a GPS09 to MX5Link with MXG 1.2
-
Thanks, I'll give it another shot.
-
For some reason I cannot see any channel data coming from my G4X? I've enabled CAN in the ECU. I had a look at the wiring for the CANF plug and it was wrong. I've since corrected that but I'm still not seeing any ECU data coming through in the Live Measures screen. Any problem solving steps to run through? Clearly I've stuffed something up along the way somehow...
-
Ah, thanks. That was an easy one!
-
I'm trying to adjust the max rpm down from 18 in the displays to match the range I have set in the Shift Lights and Alarms. I've gone into most settings I can find but to no avail. Any suggestions? I