boogie lew

Hi Vaughan already tried unplug all the link sensor that connect to the XSL but the problem still persist. At here attach the PC log and some picture when no sensor is connected Thanks no sensor connect.llg

Ok will try it and update you the output thanks

Here you go Thanks whatsapp video 2023-03-27 at 11.32.04 pm.avi rosak.llg

Hi bought a honda plug in HC96 g4+ ecu few years back . Last Sunday while cruising in town out of sudden it shut down my engine and i not able to start the car again . When connect to pclink the figure is haywire , once i connect back to factory ecu the car works normal. Attach here some pictures thanks

OK ..... Thanks for the information

i'm going to install this sensor in my link ecu hc96 using expansion connector. temp 3 for oil temp ( in PC LINK sensor type i choose STD Bosch NTC correct?) VOLT 7 for oil press ( in PC LINK Calibration i choose 1000 kpa (150PSI) TI sensor correct? )

thanks for the information

Hi, I just bought link water temp sensor to install as extra water temp for monitoring. Out of antemp so i'm going to install the sensor to anvolt with a pull up resistor. Is there any calibration table so that i can calibrate it. attach here the water sensor i bought thanks