Rms

Hi guys .OK where do I start. OK I'm running a k20 engine with a stock harness that has been re pinned to run on my link g4+ 92-95 . Car runs fine with no issue but after getting it on duno the tuner then noticed that the ecu wasn't receiving any vvt signal. Tuner is very advanced with these systems but wasn't the person to do the wiring and now I can't get a reply from that company that did it. Has anyone done this setup before and would you think this is a simple pin error location or is there more to this . Thanks

Thanks Adam. I will give that a try

HI everyone. Can anyone tell me if there is a option on the g4+ to limit start time on my dry sump build to not allow car to start to it detects a set oil pressure. ?

Just gonna download the log now . Thanks heres the log .hope it readable . thanks again Log 2021-05-28 9;07;25 pm.llg

Hi everyone. Is there anyone that can check a log for me to make sure its safe putting some miles on my new build before it goes to tuner. Thanks

Hi . Can anyone check a log over for me to run a engine before mapping . Thanks