Doig

Yes it is written correctly, it's a older discontinued item, all I can find is it works with j1939 standard and 250 k/bits speed. Even if I just get engine speed, Temps And pressure working would be something. There's no setup in the dash until it see's something correct on the CAN bus

Hey I am trying to send CAN data to a racepak IQ3 display dash using J1939 standard as i have a 230-VM-EFICAN adapter. I want to send Engine speed, water temp, oil temp, oil pressure, TPS, Vehicle Speed, Intake temp, ignition timing and injector duty if possible. I have tried contacting Holley and others about the IQ3 information but they are less than helpful. I know J1939 is a bit of a pain but it already has this interface so worth having a go with i thought.

Have received this file back from Aim technologies, is there anyway to use the link ecu to play it out to the trans ecu? DTA_Fast S series_@20211110_094051_004063.xc1

I have since found out that it is only setup to talk to fast xfi type ecus, they only seem to have 1 version of can bus across all ages of trans ecu's so was wondering if it would be the same as the protocol aim or haltech use in there dashes? Would there be a way of getting the link ecu to send this data that the dashes are used to receiving somehow? I do have a old laptop with the tciauto software on it to check any signals being sent.

Hey I have almost finished wiring up a G4X Storm ECU to a chevy with a LT1 engine and trans, the engine is sorted but am trying to connect the ecu to the transmission ecu through canbus but I have no information on setting it up for this ecu TCIAUTO 301002 I know it requires a TPS, engine speed and Map signal and would rather not tee into the new engine harness. Any help would be great