-
Posts
16 -
Joined
-
Last visited
Wastgate323's Achievements
-
Thank you so much, now it works. I have delete the old logs. and store the settings again, now i see everything i want in the logs
-
I have a issue with my ECU log parameters. In the log setup i have selected CAN TC1 and something other. But in the log they are missing. If i start logging with pc it works. Thank for help
-
Thank you, now it works
-
Hello Adam Yes i see 50-60Hz on the rear Wheel Speed in the ECU. But the Cluster dosen't work. (at the moment i only can test on the Car lift, so the front wheels aren't turn. So i set the driven wheel speed to "average rear speed" rx8.pclx
-
Thank you Adam. I try it, but it dosen't work. Should i try without Signal from the ECU? I'm not sure, but the ABS Unit read all 4 Wheelspeed sensors, and send this Information to the CAN-Bus. So the Gauge Cluster can read this Information directly from the ABS Unit? Thank you
-
sorry, my mistake. Yes, the ECUmaster EGT sends this data directly to the Plex. Is this a problem? So most of the data comes from the Link ECU and the EGT from ECUmaster. But everything is on the same ID. In PCLink i see the right EGT.
-
The Car was finally on the Dyno. Everything works betwenn the ECU and Cluster. But the Speed dosen`t work. I have change the ABS Unit from Europe Spec (Bosch) to a US Spec (Sumitomo) without DSC. The ABS light works correctly, i think. If i disconnected one Sensor the light goes on. if all sensor connected, the light goes off. Is something in my Canbus Stream wrong? RX8fertig-geƤndert.pclx
-
I need help with the Stream for Plex Display. MAP, ECT, OIl Pressure etc works well. But EGT only in the beginning. If the temperature rises higher, the display starts from the beginning. For example; 150deg. egt shows as 150deg. egt. But 250deg. egt shows as 50deg. egt RX8fertig.pclx
-
I have a really dumb question... But i don't understand the alternator control so well. If i use the test mode (Aux 4) the alternator charge the battery. So far so good. But i don't understand all the possible settings. I hope somebody can explain me. best regards Lukas
-
Wastgate323 changed their profile photo
-
i think that was the problem. I try it tomorrow. Thank you
-
Whats about the latest Firmware update? https://linkecu.com/new-features-available-for-g4x-products/ If i want to update my Firmware, the updater doesent find a newer Software. But i need it for the alternator Control. Thank you for your help
-
Thank you so much Adamw. The Engine is finally run and the Cluster and EPS works. ABS llight is also off, but i can't test it right now if it really works
-
I have also a problem with wheel speed sensors. I can not add parameters lf, rf, lr and rr wheelspeed that receive to ecu.
-
I'm finally back in the workshop. i have all wired up. Power Steering and ABS without DSC. Any device has Power supply. but the controllight are still on. (ABS, Handbrake and EPS) Thank you for your help. kind regards Lukas rx20b.pclx