Jump to content

dohctor

Members
  • Posts

    4
  • Joined

  • Last visited

Everything posted by dohctor

  1. was there any resolution to this problem? i am having a similarish issue with my PLM 4 bar map sensor on HC96+ . I am using the factory loom to connect to the map sensor . On link map sensor is on AN volt 1 channel . i have attached my senor config details below (senor type 4 bar) If i keep AnV1 error low = 0.05, and perform ecu map sensor caliberation . i get a reading of 100kpa which i presume is the error value that has been set. but then get AN volt 1 below error low value If i keep ANv1 error low = 0 , and perform ecu map sensor caliberation . i get the cabliberation error Please advise how to resolve above issue or furthet tshoot it
  2. HI, Thanks for your response , but i worked it out, i had the IAT plug incorrectly plugged into the knock sensor. (just running pre-checks before i start the motor). picking up correct temp readings now that i have swapped the plugs around On a seperate note , what to do you mean my attach copy of tune?.. is that a file--> save as and the attach the saved file, or ecu log export (assume the former) i would like to raise another problem i am having with my map sensor , would like to attach my tune for that Cheers
  3. Hello link team, requesting troubleshooting steps . I have a hc96+ connected to b18c1 engine loom for 1996 honda integra sir. All analogue volt and temp senors are showing "OK" status on run time menu. However , while my ect sensor on AN temp2 channel is showing realistic coolant temp of around 26 degrees. my IAT senor on AN temp 1 channel is showing 150 degrees C. worryingly , there is no error codes thrown by the ecu and the temp reading remains at 150 even when i disconnect the IAT sensor from the loom. Let me know if you need any further info Cheers
×
×
  • Create New...