Silvia86

basically pinout for the extra stuff i'd need to add in, so the extra cam sensor and then the two vanos solenoids, everything else is already existing in the loom when i went through it yesterday

Thanks for the reply Adam! Would you foresee any issues using K20 coils, or them being not adequate enough to do the job? I figure they ran without fault on the last engine when the limiting factor was not ignition or fuel, so it shouldn't be an issue here either The 52tub28's or at least this one wired with a siemens ecu, as far as i can tell electrically these are basically an m54 and externally in valve covers and things they look very much identical too, so like you say would be just a matter of using the m50 crank sensor and m50tu cam sensor. would it be rude to ask if there is a pinout chart available at all? Thanks

Hi, looking for some information on whether i can achieve what i need to with my ecu. In the car currently is a g4+ monsoon, it was being used to run a M42B18 with ITB's and K20 coils, ran all that no problemo. the ecu setup and wiring was done by the previous owner of the engine. After a few years of racing that we're now going to an M52TUB28 and ideally it'd be nice if i can run that on my current ecu in like a batch fire setup or something like that. I also am reading things about using M50 crank sensors as well. If anyone could shed some light that'd be much appreciated. Thanks

interesting, i have been tossing up whether to change it to the strada dash, perhaps now is as better time than ever! as for the iq3, it would be 30 something pins, it is the later v2 version which has the built in can rather than needing the vnet expansion if that helps thanks for your time so far mate, appreciate it

TBH, im not sure, ecu was supplied with the engine. The link website only lists a monsoon in G4X and it looks the same as the picture, EFI isnt really my specialty so im learning as im going and if there's a difference im honestly unaware of there being one. Thanks

Ive attached the tune for you mate Thanks! M44 E85 with Candata.pclr

Hi, i have link g4x monsoon, which is connected to a haltech iq3 dash (later version with the v2 protocol) and also uses a haltech wb1 wideband (both connected via can) the dash has worked flawlessly up until the wideband is connected and the engine running (the dash communicates with the wideband connected when the engine is not running), at which point the communication with the dash stops and any values that were displayed count back to zero. The dash works correctly engine running with the wideband not connected. Any help or suggestions would be appreciated. Regards.