ihaveaquestion

That makes sense. Thanks again for the quick reply/help, really appreciated!

Figured I'd follow-up on this, checked the included calibrations and there was indeed one for Delco. It's similar, but doesn't match 100%, not really sure where the difference is coming from, theoretically given the same pullup resistor value is used the values should be the same. Might be the tolerances that you mentioned I guess?

Perfect, all clear now. Thanks for the clarifications, very helpful!

Hi @Adamw Just wanted to check, these values are in Ohms, right? I've bought a NTC1-8 because it was the only option I could find with a DTM connector on it and need to fill in the calibration table in my datalogger (MoTeC ADL3) so I just wanted to check to make sure I fill in the correct values. The logger also has a 1KOhm pullup on its temp inputs, so I expect it should work the same/require the same calibration values. And these sensors are all calibrated out of the factory? What is their expected accuracy/deviation?