I have a 4age 20v with r35 coils.
The wiring that came with the coils has two 18awg feed wires. But I am using an autosport bulkhead connector that I need to get the feeds through but it only takes 20awg wire.
1. Can I split the two 18awg down to four 20awg wires?
2. Can I run one 20awg wire per cylinder from the connector? Or is that too small.
3. Probably a little dodgy, but trim three strands off to fit the 18awg wires into the connector.
The wire length will be 300mm for cylinder one, and about 200mm for cylinder 4. The after the connector they will go to the full size if the 14v feed
Thanks.
Ryan
