lc_fist

I'll load it in and try it out, Thanks again

Also I have another question, how can I set the CAN to display the mileage on the MOTEC C127?

I flashed the file in and everything was fine. thank you so much

Hello I got my G4X ECU to send the generic dash output to the Motec C2 on CAN 127 - everything works fine. I added fuel level on AN8 on G4X ECU, calibration table 8 sets the calibrated voltage, PCLink shows the fuel level accurately. I add the transport stream to 5, how do I add this channel to the CAN 2 to the Motec, or do I need to go and buy the I/O? Is there an example I can refer to for help? thanks EVO9 Link ECU G4X.c127v61 EVO9 G4X.pclx The value will change slowly according to the pull, I have calibrated