ShaZam278

Thanks man, I'm finally understanding it all.

Thank you for all this information. I bought a CAN splitter and plan on plugging my X-Series into one port and Link's CAN Gauge into the other. For the expansion loom, I bought a 6-pin connector that will accommodate for every thing I add into the expansion loom. All this being said, can you tell me exactly which port to wire each thing into? Because I know "Aux 6," for example, is an an Aux output, and "Gnd" is ground, but I can't figure out the rest of it. I'm still confused on "DI," "Volt," and not to mention the blank ones. Thanks!

Hello guys. I am fairly new to wiring so please excuse the nooby questions. I am switching from AEM V2 and am trying to migrate all my D connector wires onto the Expansion looms I have on my S2000link. The things I added to my AEM V2 are: surge tank twin pumps, AEM X-Series AFR, flex fuel, and MAC boost solenoid 3 port. Here is how I did it: How would I go about migrating these inputs/outputs to my S2000link? Here are the expansion looms: Sorry for the long post. Thanks in advance!