madablackmon
Members-
Posts
9 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Blogs
Everything posted by madablackmon
-
Thank you Adam. I gave it a try on the bench with a few of my older laptops with the same result. I guess I'm going to just send it in for repair. Thank you, Adam
-
Has anyone had the g4+ freeze up while installing a firmware update. I can't connect anymore and the blue light on ecu has gone out. I am able to restart the firmware update by repeatedly clicking on restart of firmware update but it fails every time after the power cycle prompt and I receive an error code 1002. This ecu was working fine just wanted to update the firmware. I have power to the ecu and have disconnected and restarted several times withe the same result. If anyone has any ideas the help would be greatly appreciated
-
thank you
-
adam. thank you i see in the fury x in the trigger 1 i have a setting for number of gaps and sync tooth that i dont have in the g4+. should i leave them at a setting of 1 for both
-
Adam, I ended up buying a new fury g4x to replace my g4+. i have used the clipboard to move the files over to the furyx I feel that i may have missed something because the motor will not start . is there a chance you could check the two files for me ? I have moved a few auxs from the original file to a new location but i feel like I'm missing something in the inj or fuel settings . thank you any help is appreciated thank you, adam BCM_HRC_ProX_55_Gas_senecafalls (1) - Copy.pclr ANB HRC2.pclx
-
Adam, Thank you I'll give it a try Adam
-
Adam, The help would be greatly appreciated. All I am trying to control via the CAN is my fuel pump and water pump thank you, Adam BCM_HRC_ProX_55_Gas_senecafalls (1).pclr HRC2 pdm2.pdmc
-
Vaughan, Thank you sounds a bit complicated I was hoping it was just something I forgot to click in the settings Thank you for your time
-
Hello, Do any of you have any experience with the can setup with the Link Razor pdm. I have the can wires on can 2 wired to the B connector canH and canL. For some reason I can't get the g4+fury to discover the pdm device. I'm new to this set up any pointers would be greatly appreciated