I have recently purchased an HC92X with the E-throttle add on, I realize now it does not have a dedicated knock sensor input in the pinout. The engine this will be running is a modified Honda D16a6, it has been bored and crank swapped with one from a D17a2, as well as a lightly ported D16z6 head so I will have VTEC on it. I have been running this engine boosted on a stock ECU with a Moats Demon II, I purchased this ECU for the ease of the install. So I wouldn't have to modify the wiring harness to new plugs, just swap around and add a few pins. I was wanting to know is there a way that I could either wire a knock sensor to an Analog or Digital input? Or would I be able to use the Can Bus stream to add one in? I read in another thread on here that it might be possible. But I do not see how the modification is done. I have a link dealer local to me if they would be authorized to do any adding of wires to allow it to function. I hope there is a way to add this function, as I see in the software side it has knock control tables and functions when I load a 92-95 Honda base map in.
