Hi, rpms are the same in cluster vs log ? I have 6000rpm in the log but the cluster are 5700rpm+-
rpms at idling are similar…
st185cs ON tst205 g4+ lastest firmware
its possible adjust this?
Yes, of course.
but In the G4X are in correction timing table in 4D for hi-load, but in axis are seconds x rpm
At 3ª-4ª-5ª gear in hill climb its perfect for this
In g4+ not have some table
hi this its my 4D ignition table , engine 3sgte turbo gen2 in link g4+ boost level 215-230 kpa over 70-100% of tps .
Ignition table 1 in 3d run at 12º at 220kpa in 6000rpm .
i think what of high loads at more of 60% tps its necessary remove timming for knock
what think of this?
regards