IncepTioN

I can manually adjust the idle control valve to be closed off more and then see if that helps? As its sitting about in the middle of the adjustment slots on the valve body. Also just noticed my map calibration is set to subaru v7-8 instead of subaru v1-6. would changing this help at all? PC Datalog - 2023-02-9 6;15;01 pm.llgx PC Datalog - 2023-02-9 6;19;58 pm.llgx

Updated the base position table. Also set the pull-up resistor to on for GP speed 1. Still having same issue of dipping down to 600rpm but this happened when stationary as well as pulling up to a junction and traffic lights. 1st log is start up. 2nd log of me taking it up the road.

I just loaded in that map and its running sweet. Ive data logged it here but will also let it get up to temp and see how it is and log that aswell. just took a log of it up to temp and also took it for a wee spin up the road.

Yea that’s the one that was in the ecu when I got the car back. I just saved it as a back up. Yea, v4 sti.

This is the original map before I started tweaking stuff, any time i try changing anything and it doesn't work i put it back to this map. I've took my idle control valve off cleaned it and put it back together with new seal and gasket. I don't think i needed to do this since all was working ok on the original ecu but i did it just in case. Ive no idea why any of the targets are set the way they are I would need to get talking to the guy who set it up and mapped it. Its a fully forged engine but still a 2.0 and everything else is standard apart from the fuel pump which is a rcm 2338.

I recently got a G4x installed and mapped but its having issues idling. Once you start the car its fine but then after a few minutes it starts bouncing from 1200-1500rpm. Ive tried changing values on the idle base position table, idle target rpm table and tried changing values for the overrun fuel cut table but nothing seems to be fixing the issue. I cant get my car in at the moment to get looked at so that is why I've tried to see if I can fix it. PC Datalog - 2023-01-27 4;12;51 pm.llgx