PopesSimpleSpares

Ah ok thanks for the help

Have added the expansion connector but now in boost control setup i cannot find aux 15. however it is visible in the fuel pump control. I'm going to change to the other expansion connector and use aux 8 instead but just a bit confused as to why I cannot see it here.

Any update on this? I think I'm having a similar issue

I tried the original map I got back from the first tuner and the ignition angle seems to change more smoothly but it gets the same spike in lambda which I don't really understand why its happening PC Datalog - 2023-06-12 12;41;16 pm.llgx

I've attached some logs with lambda readings of the stalling and the hesitation. thanks PC Datalog - 2023-06-8 10;53;26 am.llgx PC Datalog - 2023-06-8 10;52;38 am.llgx PC Datalog - 2023-06-8 10;50;02 am.llgx PC Datalog - 2023-06-8 10;50;34 am.llgx

whoops, attached now PC Datalog - 2023-06-7 2;04;02 pm.llgx

I've been going a bit in circles trying to fix a couple things. first the idle keeps dropping out as it warms up around the 70 degree area, and off idle there's a new hesitation that I can only guess is being caused by the ignition setup. no longer having issues with the AC loading. The log I've attached from today is just the hesitation off idle as I didn't have the laptop hooked up when it was having issues. The current map is basically all the updates you've given plus some dashpot and the idle base position table setup - no changes to ignition. 7 june changes.pclx

Had a yarn to a mate and he pointed out the switchover from the main ignition table to the idle ignition was quite harsh. I've retarded the ignition table above -20 a bit, set the idle ignition target to 15 and reduced the switchover rpm to 500 above target. Will test it in the morning but does this updated map look like it might respond a bit better? 350z 25 may ignition update.pclx

Hey so i got the dashpot setup so it would consistently catch the idle and after leaving the car for a couple hours it drove great with no issues. When I started the car after it being stopped for 5 minutes I got these 2 logs. Where would I make a change to prevent this? thanks PC Datalog - 2023-05-25 2;25;55 pm after dashpot.llgx PC Datalog - 2023-05-25 2;27;05 pm compare.llgx

ok, so i started it from 40c and did the idle base positions up to 90. after this it stalled and wouldn't catch even when I pressed the accelerator. Stall after Idle changes.llgx

Ok thanks for that, will let you know how it works out

Disregard, for some reason the changes made didnt store, will try again now

Driven this morning, still stalling, heres a couple logs and the updated tune. I'm still not sure what's causing it to drop out. seems to happen only when its warming up. Thanks PC Datalog - 2023-05-24 10;23;12 am stall after.llgx PC Datalog - 2023-05-24 10;25;17 am stall 2.llgx 350z 23 may Idle setup.pclx

Settings all changed to reflect suggestions, did a cold start warmup and changed the idle base position table to the logged values - I assume it's fine to just copy the value from 20 through to -20 and from 90 through to 120. Already can notice the idle catches a lot better. Will take it for a drive in the morning to check how the acceleration has changed. Thanks

Finally had it stall a couple times. This is a log for that. thanks