Jump to content

Dynotech NZ

Members
  • Posts

    35
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Dynotech NZ's Achievements

  1. Inshan  Post you .pcl file, ill look at it and see what your tuner has done and show you the avcs looks like on a 2002 jdm sti I tunedon our dynapack dyno last week.  Dynotech Industries
  2. Got to your fuel table Right click the load axis Select axis setup Under Y axis select 'TPS main' Push init axis button Push Apply button Done
  3. Hi Ross do you have a good base/starter map for R33 G4 plugin RB25det
  4. What firmware are you running? Try upgrading to the latest, as it works fine for me 4.8.5  Send me your map [email protected] and Ill take a quick look for you  Phil
  5. Same as the Bosch mate. Â However I would highly recommend fitting a new Link item to the intercooler pipe just before the throttle body. The std 1 in the inlet manifold will suffer from heat soak!! I have tried and tested this on my own Evo 9. Â Phil
  6. 7v=2.36 Â 9=1.320 Â 10v =1.17 Â 11v=0.95 Â 12v=0.8 Â Â 13v=0.67 Â Â 14v=0.56 Â Â 15v=0.46 Â Hope that helps
  7. I can confirm i have the same problem with latest 4.8.1.1033 Â Phil
  8. Just buy the link 3 port soleniod and wire to the active soleniod wiring (not the passive) Â Done this on my Evo 9, works perfect and I use close loop boost for accurate boost control
  9. Gear calc can be calibrated from speed DI input
  10. Thanks Ashley Yeah i noticed that table, it is labelled as table 8 and all values were half my target as you say Keep up the good work!! Phil
  11. And here is screen shot with firmware 4.8.0 Thanks Phil
×
×
  • Create New...