BhdrAltn
Members-
Posts
12 -
Joined
-
Last visited
BhdrAltn's Achievements
-
orhanovali started following BhdrAltn
-
When I take my foot off the accelerator pedal, car shakes back and forth. I would be grateful if anyone can comment on the attached log file and maps. Log 11-09-21 7;26;47 pm.zip 05-07-2021.pcl
-
First of all thanks a lot to paulr33 again. I used his code and tried to adapt to nextion display . I am not a programmer. What I did serves what I want. Any suggestions to improve the program, speed, qualities are welcome. You could find everything needed attached to this post. Main Hardware Used ; Arduino UNO CAN-BUS Shield V2 (Seeeds Studio) 2.8 Inch Nextion HMI Thanks & Regards VİPEC V44 ARDUINO NEXTION.mp4 vipec nextion digital font.tft VIPEC_ARDUINO_CANBUS_NEXTION.zip
-
BhdrAltn reacted to a post in a topic: DIY vipec display
-
The arduino code would be helpful since I am trying to similar thing with nextion screen. I think , I can adapt the sending data to display section for nextion. Thanks
-
Hello any update on this project? Do you mind to share your final code? Thanks
-
BhdrAltn reacted to a post in a topic: Map for Bmw M30B34
-
Hello Is it possible to run bmw economy gauge with vipec v44? Thanks
-
We almost finished . Some little think left . Cap for distribitor , wide band installation and tuning left .
-
From tuning menu chose Runtime values . Under Analog Tab you could see Analog voltages
-
Hi Dave Air temp sensor is installed on the intake manifolt . They are old sensorsfor motronic and gauges in the car. Regards
-
Hi I use 60-2 from E32 M30B35 I have bosch 0280150714 type injector. M20 map will be helpful ( [email protected] ) This is my car and what i done .
-
Trigger calibration done. Map will be helpfull.
-
Hı I am Bahadır from Ankara TURKEY I am traying to install V44 on to 1986 BMW E28 M535. I have difficulties on making trigger calibrtion. Trigger offset and Referance timing in the are locked and I can not enter any value to them in Set Base Time Menu. Probaly I missed some easy issue but I cound not find. Any idea or comment will helpful Regards . Ps: Is there any body used Vipec on Bmw M30 motor and have base map fot it?