Jump to content

turbodude

Members
  • Posts

    14
  • Joined

  • Last visited

turbodude's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. Figured it out. It was a punched wire on the 5v supply. Thanks everyone!
  2. Yes one connection point and 3 pins. Using a Ford tps
  3. yeah i tried clearing the fault code. and then it pops right back up. ill try lowering the value today. im getting voltage, so i know its not that. so strange. i should mention im using a ford mustang TPS.
  4. Looks like the values are correct. Any other clues?
  5. i have an error code, not sure what has happened, one day my tps stopped reading normally, and locked at 10%. tested the tps itself and its fine and showing resistance. Any help is appreciated! ECU Fault Code 14: An Volt 2 below Error Low value thanks in advance! its a 1993 mr2 turbo with the ST205 vipec v44 plugin
  6. i figured it out, i think it was because i was on a GP Output i couldnt trigger the relay. so i ended up putting the light on a switched 12v, and have the GP output switch on the ground and it works everytime now.
  7. Hi guys need help getting the shift light to work. I have a 12v led wired in with a relay on Aux8 signal triggering the relay. St205 plug in unit. GP output on Aux 8. I have the aux 8 trigger going to the switch of the relay, and the relay itself triggering the led, but it doesnt work. Any clues?
  8. after further investigation, the mr2 has two switches, one at the top of the pedal and one on the bottom, im going to use the bottom, it uses a ground to turn on and off the cruise control. i prefer this because i normally launch the car at the bite point of the clutch rather than the floor. IS it the same procedure? Figured i would just cut the switch, ground one side, and then run a wire back to the Cipec expansion harness to DI4. Would this work?
  9. its positive input, it complete the circuit for the starter.
  10. Ok I have the expansion harness. Its my play car but I see what your saying. How would I wire one of those spare digital inputs to my clutch pedal switch? Thank you.
  11. Hi I have a st2p5 vipec unit for the mr2. Wondering how I would setup launch control using vehicle speed.
  12. ok, now i have everything hooked up, thank you! My question is how do i change the calibration table to match that of the MTXL for the output, currently i set it to the Innovate Lc-1 calibration but it reads wonky and definitely inaccurate I went into CAL Table 1 to try and change it, but i only have outputs, innovate suggests 0V = 7.35 AFR and 5V = 22.39 AFR. sorry for the stupid questions, but auto tune wasnt working correctly at all because of this. thanks again Simon
  13. Hi i am having some issues wiring my MTX-L into my Vipec mr2 Plugin (st205). The yellow wire and brown wire are analog 1 and 2. Now with an mr2, it shows two different pinouts for Oxy sensor. Aux Inj6 - "Oxy heater" An Volt 1 - "Oxy signal" which wire of the MTX-L go to which? thanks in advance!
×
×
  • Create New...