r32pat

So i found 2 things. 1. A spreadsheet with some fiddling i could work out the numbers using a formula that needed a BETA figure. 2. Then after all of that i found a 100 times better VDO PDF of the actual thermistor itself with a much broader table which answered my question. I just needed to google harder!

Hey All! I have recently wired in a VDO temp sensor 320.028 for watching oil temp on the sequential box i am running. Unfortunately i was unable to tap the housing and fit one of the more common temp sensors preloaded into the vipec before an upcoming event. So i am stuck with this sensor for now. I am looking for some assistance with the math for the CAL TABLE. Here is the table from VDO. DEG C Ohms 40 481.5 60 221.2 75 128 82.5 102 87.5 89.3 92.5 76.8 97.5 66 102.5 58 107.5 50 115 41 125 32.2 135 26 145 21 160 15.1 180 10.2 In the VTS i used Cal table 3 with 10C increments starting from 40C. As you can tell from the table above the VDO table provided doesn't work increments of 10C. So wondering if anyone can assist with the math required to calculate these figures in 10C increments or if i should be setting up the cal table differently. I have used TEMP 4 as the input for this on a V88 GTR Plug and Play. Any help will be appreciated.

And we have a Winner!! Working as intended! Cheers Guys. Aims Dash is now showing gears using the AN Volt GP Input using CAL Table 1.

Cheers guys! I will give it a go and report my results!

Hey Guys, Had a V88 plug and play in my R32 skyline for a while and love it! I have recently fitted a dogbox running a potentiometer for gear readout. I want to run it through the v88 so I can do data logging and display on my Aims MXL Dash. While I understand that the vipec can do gear detection from a speed signal it cannot do this if the car is stationary. I have come up with an idea I wanted to run past the experts to see if it is viable. Could I use one of the Analog Volt input in GP Mode and setup a custom cal table say cal table 1. Set the input units to volts, Output units to NONE, Table start at 1 an intervals of 1. Then configure each interval with the voltage detected in each gear. The gearbox is only 4 speed so I would have to put stupid numbers in the boxes for 5-16 of course. Then CAN BUS map that to the gear read out on the dash. Or am I barking up the wrong tree and there is a better way to do this ? id like to look into Gear cut later on aswell so if there is a universal solution that supports both id consider that! Cheers in advance! Pat

Hey Guys, Been a member on the forums for a while and I need to post a topic in the V Series forum. I noticed on the weekend that I couldn't post and the reason was I hadn't put my V88 serial number in my user profile. I have done that now so just wondering if someone can approve my account for posting there. That way I am asking the question in the right forum. Cheers Pat