Adamw
-
Posts
20,005 -
Joined
-
Last visited
-
Days Won
1,277
Content Type
Profiles
Forums
Events
Gallery
Blogs
Status Replies posted by Adamw
-
I have got the Link Ecu XTREME, and installed and connected it to the BMW E36M50B25 vanos. How can i make the vanos work? Should i set up any special configuration? Could you please advice. Maybe you have any guidelines on the correct vanos set up? Because it seems doesnt work.
-
Please post on the forum relevant to whatever ECU you have - G4, G4+ or G4X...
-
-
Hi Adam, im messing with setting up my pmu16 and keypad with the thunder ECU on the bench. I have everything working from the ECU to the PMU on CAN and it all seems to work fine.
The thing i want to see if you can help me with is how to receive the stream im sending from the PMU back to the ECU with the keypad states to activate CAN Di's etc.
This is what the PMU is putting out when no keypad switches are active:
ID DLC Bytes freq
100h 8 00 00 00 00 00 00 00 00 20hz
This is with one keypad button pressed
ID DLC Bytes freq
100h 8 01 00 00 00 00 00 00 00 20hz
Ive tried a few things but seem to going round in circles. The ID is hex also in the PMU so i assume the id in the ECU will be 256.
Hope hat makes sense.
Phil
-
Oh, forgot to say yes your ID would be 256
-
-
Hi Adam, im messing with setting up my pmu16 and keypad with the thunder ECU on the bench. I have everything working from the ECU to the PMU on CAN and it all seems to work fine.
The thing i want to see if you can help me with is how to receive the stream im sending from the PMU back to the ECU with the keypad states to activate CAN Di's etc.
This is what the PMU is putting out when no keypad switches are active:
ID DLC Bytes freq
100h 8 00 00 00 00 00 00 00 00 20hz
This is with one keypad button pressed
ID DLC Bytes freq
100h 8 01 00 00 00 00 00 00 00 20hz
Ive tried a few things but seem to going round in circles. The ID is hex also in the PMU so i assume the id in the ECU will be 256.
Hope hat makes sense.
Phil
-
Hi Phil,
Are you using the "canbus export" (main project tree) or "export keypad state" (keypad setup) function? The CANbus export function is generally the better option so you can send the actual channel after latching or whatever function is applied.
But to answer your question I would expect one of the two setups below would do it - probably either will work but some devices count the bits from the opposite end.
-
