1320MINI

I would use Link CAN Lambda or AEM.

Doesn't the Motec have a Q key which will add/subtract the amount needed.that would be a good feature to have.

Hi Guy's, How hard would it be to add a basic nitrous control to the ecu. Basics like : Delay, build time and maybe a option to fire the fuel solenoid a coulple of milliseconds before the nitrous solenoid.

Hi Guys, We have a analog channel measuring Clutch pressure. Is there any way to use the information to activate the ignition cut We are on a H pattern which is being difficult to go in at 9000+ RPM Thanks

I could only get the CAN Lambda working on Lambda 2 . I had the same thing where it would pull maximum trim, i put it down to the closed loop looking at lamda 1 which was unused and sitting at 7.45:1 afr. I'm yet to load the latest but will try tomorrow.

The green wire on the OBD will not read engine speed once the link is fitted. We normally tap into the coil wire to have a anolog RPM signal. Also disconnecting pressure sensor plug that plugged into the air con will make the fans run constant. We just unscrew the sensor and plug it back in and the fan's work as normal.

Been having issues with the CAN Lambda on a G4+ MINI LINK. Hopefully this will fix it.

Hi Guys, Ive been looking into installing 4 EGT's on our Engine, I spoke to a guy who can supply the sensors but said each EGT will need an AMP. The Thunder only has 2 EGT channels. Is there a way of running 4 at the same time? Thanks in advance.

Hi Guys, We are going to use our G4+T in our drag car, i was wondering if there could be a way where we enter the timing ticket in to the log that would tell us where about's we are on track (60ft,330ft,1/8th mile, etc) and what time we are into the run. We could activate the run with the G meter. I have seen one of the default logs as a drag run and wondered if we can set ours up the same? Thanks for the great work guys.

Any joy with the extra tabs for the latest PC Link? Also how about adding the AEM map sensors and Wideband to the listed sensors?

Hi Guys, Loving the new software however, now we can only see 3-4 tabs, so jumping from one to another which isn't in sight is a little annoying, i had around 10 or so to help with certain areas. Also could there be a way to lock certin tables, i don't believe in locking the whole map but i would like to lock the odd table for saftey. Many thanks and keep up the good work.