TechDave

We cannot run the VANOS on this engine, it has two solenoids per cam, 4 cams, therefore you'll need 8 aux drivers set up for this and only 4 of our aux drives can be used for vvt.

There is no Linux version of PCLink

Trigger Pattern is the Holden Alloytec III Offset -213 I can't remember which cam we synced off, I think intake, exhaust wouldn't sync, something to do with pull up voltages. There are a few flavours of ecoboost cam lobe profile, 3 and 4 lobe, ours was 3 lobe, cam centerline offset was 140. I know from destructive measurements that the pump displacement is 0.254cc/lobe Peak and hold driver 9 and 5. Didn't get too far into deadtime or pump calibration. There's a bug in the pump calibration table, you MUST use all 16 columns. You must power cycle between changes to Pump Cam Centerline. We had it idling away on an engine frame, tracking fuel pressure nicely.

Nope.

This isn't just a mock up? This is functional?

Does anyone have this sort of wave saved as a log file?

Grab us a PC Log file too chief.

terminating resistor on the CAN Bus?

How many total do you want?

Batt voltage wasn't logged in that file, so that's not much help. Try doing a PC Log, it captures everything.

Looks like this:

Attach your basemap or send it to [email protected]

Some tablets have two USB ports (one can be used for charging, the other for data) Some tablets have a separate power connector

http://dealers.linkecu.com/can-lambda CAN Lambda

You may have also accidentally pulled another pin out slightly, take a look in the front of the connector and you'll be able to see which pins haven't seated correctly.

Correct.

Hi guys, I'm based in the UK, send your basemap to [email protected] or attach it here.

I don't have a date for 5.6.6 yet, hopefully soon, we've been testing it internally.

It's a graphics driver issue, fixed it for 5.6.6

GP RPM Limits have an activation delay for this. Start up activation delay too.

No no no, we're not releasing two new plugins. Fake news.

If they change it back though you won't see any change in the map, worth having a look though. At this stage there's no way to know what they did. A log or even version control system for tuners (and users) is on the wishlist already. edit: could try downloading the log stored in the ecu.

You can plug a knock block into the microphone jack on a laptop and monitor it in PCLink, you should be able to listen to the mic input at the same time, you may need to go to your sound settings and click "listen to mic" or something. Here's my jamming master of puppets into the microphone on my laptop, I can hear the distorted mess that comes out on my ear piece.

Just moved you over to the wishlist there. I'll add it to the list.

We updated PCLink last week, but had to take it down again after some bug reports, should be back up soon. I found my laptop slow too when I first got it, a driver update fixed it. Make sure to get the proper drivers from the vendor.