Jump to content

neil brown

Members
  • Posts

    365
  • Joined

  • Last visited

  • Days Won

    3

Everything posted by neil brown

  1. https://www.torqen.uk/brands/link-ecu/accessories/looms-and-cables/g1-g4/52777-link-ecu-serial-link-ser.html 100 pounds new
  2. they are not obdII due to their age, as these were out well before obdII was thought off you can see all info on the hand controller if you have one
  3. neil brown

    Subaru Speed g4x

    Friend had dccd pro in his car due to above issue which was tapped into front left abs sensor Speedo would read 20 mph sitting still and bounce about all over the place when driving and also brought on abs fault light which would not clear Chances of it working is slim I'd say as he decided to sell the car in parts to recoup his money
  4. neil brown

    Subaru Speed g4x

    Can't tap into abs as will thro abs code on that wheel Later 6 speed boxes from wrx hatches and legacy don't have a speed signal from box but is done over can from the modules on board See picture with circle is where's the speed sensor is fitted if got a blank then there is no drive fitted for the speedo sensor
  5. Is the plug touching metal as that's the return path otherwise won't spark Do the coil packs require an ignitor separately or have they an ignitor built into to them. Did you set up the dwell times in the ecu . Dwell times 8V 5.34 10V 4.69 12V 3.93 14V 3.40 16V 3.40
  6. neil brown

    Fuel pressure

    put the old pump back in if runs fine with that, check out the new pump and could be a faulty batch
  7. Sg9 sti has DBW and AVCS as well Moonson not suitable as above have stated
  8. It will be a jgn sg9 sti forester with drive by wire throttle from 2004 to 2007 model
  9. Cable and Tuning pc box required That depends if ecu is either pc tunable or hand controller only Put picture of main board sure Simon or other can advise
  10. will need an external e-throttle module for it to work
  11. Have you done a compression test on the engine as low compression will give you a misfire And what engine are you running as well
  12. Silly question Fuel gauge shown empty on dash Is there enough fuel in the tank to create fuel pressure
  13. Maybe dwell times are wrong to suit the coil packs
  14. Don't if allowed here But there was a silver and blue g4 storm ecu, so picture and price would help you massively if wanting to sell a d your location might help
  15. neil brown

    Wrx104+ ecu

    At the moment I have a silver storm g4 installed for last 6 yrs on a home made patch loom
  16. neil brown

    Wrx104+ ecu

    Can drop in my g4 file just now to g4+ and auto converts
  17. neil brown

    Wrx104+ ecu

    Is it possible for this to be used on a gc8 ver 4 if adaptor loom was made and change settings to ver1-6 timing set up or do I fit newage timing wheels instead Thanks neil
  18. G4 units can only send out can data It can't recieve can data You would need to use an AN input and set it up as wideband on lc1 settings from drop down menu
  19. Usually with the subaru set up If wheels are strapped on flatbed and left in gear whilst strapped What happens, the rock of car whilst moving causes the belt to jump on the crank sprocket thus putting out belt timing Reset belt timing and do compression test, suspect bent valves now if been trying to start it Can usually run a 1 to 2 teeth out but lumpy
  20. No as g4 can only transit data over can or rs232 It can't recieve data only g4+ onwards
  21. Doesn't support it Can send data. Ut not recieve over can, need to an anolugue input
  22. Possible Subaru impreza ver 1 and 2 Possible tuning only by hand controller as no markings on chip
×
×
  • Create New...