neil brown

Try a 1v

What’s the arming voltage in the settings

Will need to check out the aettings around 6 yrs it was sent to NZ for a new main board so hopefully it can work on can Where do I find the settings on this unit for to see if rs232 or can

Ask for 4 bar part number mpx4400ap I think

You can send it to link and they can upgrade it

Basically yes and remember to turn off an5 as cant have 2 map Sensors active

Looking at the g4x platform as have this dash on my g4 storm unit Does this work with the g4x as didn’t see it on the list of drop down option on user transmit menu just wondering before u make my mind up of an ecu upgrade from silver g4 storm

Will need to look at it

Looking in upgrading ecu to either a moonson or storm So can use extra inputs over can is it possible There is 0-5v inputs and switch to ground inputs as well Plus got link display running as well need to check if can run over can as well

Adamw thus is what am asking about https://www.ecumaster.com/products/can-switch-board/ If that’s not compatable what else is

Does this work with the g4+ platform ta Neil

Can you see engine temp on the laptop

Translate the first post into English it might help you

Mods if not allowed you can remove just wondering of all the folk who have upgraded to the new g4x units what were you using and what are you selling on as looking for a wire in ecu upgrade to replace my wire in g4 storm silver case

For what car there is base maps in the g4+ software for a range of cars

Since having the 6 speed box fitted on gears 1-4 boost is solid as per target once in gears 5 and 6 it seems to overshoot and pulsey before settiling down on 2 stage closed boost control with stage 2 being active at 30kpa of target same in high and low boost any ideas before I take a trip to the mapper

Have you tried engine tuner in Plymouth

Where about a in U.K. maybe a dealer could help you

What air filter you running and are you running maffless set up panel or cone type just in case of restriction

What ecu ?

Can answer point 3 unlock code is only applied once when it’s new as shipped locked the tuner who did map and put a pin code in to stop people accessing map, if that is the case you won’t be able to modify map but can save map to laptop you can get ecu serial number when you connect to ecu and look under info

So what’s connected to the triggers cam and crank sensors

Have you read this thread about the 2.5 camshaft sensors to the Do you have avcs heads on the engine

Same map as used on the 2.0 ltr and same set up be fire swap have you increased the master fuel setting due to bigger capacity