Skeeed3r

Thanks for the manuel and the Config But to purchase i musst Choose an Protocol -->

Ok, but how do I get the Motorsport firmware to run with the link? and which Protocoll i need ? CanOpen or J1939 thanks for your Support

@Adamw any change i can order one?

I am also interessted in

Very nice, can you share your Config ?

damn that sucks

Hi, will they work with the G4+ ? If not ... voting started

and can you test it without PDM?

without PDM ?

i used this one http://www.turbofast.com.au/TFelectronics/PageFiles/CAN_EGT_Amp.html never get any Problems with these.

@Samuarai Supra if iam right do you use the Toucan Display Keypad function without a PDM ?

Fueltech release a new Keypad: https://www.fueltech.net/collections/switchpanel/products/switchpanel-8 @Adamw What do you think, could be worked with the LINK ecu ?

Hi everyone, did anyone know if the new Can Lamdba from ECU Master working with the Link G4+ ? http://www.ecumaster.nl/en/accessories/lambda-to-can.html Thanks

Did any Keypad know work with the Link Ecu ?

Hello everybody did anybody run a Traction Control Setup with Dirve by Wire ? Idea is to make a Traction Control over the throttle body (traction lost reduce the opening level from the throttle), this should be possible with a table %Slip and throttle target. Know my problem is to do this for every gear separately. Anyone have a idea ? Thanks Regards